User's Manual

-9-

2) Powering by Batteries

V-Mount Battery Anton Bauer Battery

* Batteries: Voltage 12~16.8V; Recommended ≥15A continuous discharge.

* The LS 300x can be operated using a single battery for up to half of the 

xture's maximum output. Plugging the light into AC

power

or using two batteries allows you to utilize the light's full output. When powering the light from a single battery, you mus

t install the

battery on the right side of the of the control box, or the light will not turn on.

* Do not use non-14.4v batteries (batteries with voltages outside of the 12-16.8V range). Using higher voltage batteries will

damage the power supply and the lighting xture.

* Only use batteries that support the necessary continuous current discharge speci

cations mentioned above. If non-compatible

batteries are used, the batteries will enter a protection state and the lighting xture will not operate as intended.

* Customers can choose V-Mount or A-Mount battery plates for their control boxes upon purchase according to their needs.

1) Powering by AC

7. Powering up the controller

Neutrik® powerCON

Male Connector

Neutrik® powerCON Female

Locking Connector

AC 100V-240V

PUSH

To disconnect the Neutrik® powerCon cable, pull back on the yellow release tab on the

cable connector, and rotate the connector counterclockwise.

ai15858101745_LS_300x Product_Manual_EN.pdf 10 2020/4/2 下午2:49