Assembly Instructions

Wireless Power Charger

1. Description

Wireless Power Charger System

It is electromagnetic induction wireless charging system.

Wireless power charger transmits 10W power to mobile.

Qi (WPC) certified cell phone, which is a standard for

wireless charging, or a case dedicated to wireless

charging, can be used this system.

※ Reference

• Qi : One of the wireless charging standards

• WPC : Abbreviation of Wireless Power Consortium

• Electromagnetic induction : When an electric current

is sent through a coil (a wound-up cable), it creates a

magnetic field whose action generates another electric

current in a second coil

2. Product picture

3. Product organization

1) PAD

2) TOP COVER

3) COIL ASSEMBLY (MP-A13)

4) COIL SPACER

5) PCB ASSEMBLY

6) SCREW

7) FAN

8) HOUSING

9) LABEL

4. Product features

1) Wireless charging for automobile

2) Support high speed wireless charging (10W)

3) Apply coil cooling function by FAN

4) Apply FOD(Foreign object detection)function

5) Apply wireless charging system protection function

(Over voltage, Over current, Over temperature

prevention)

6) Apply Qi 1.2.4 ver

PAGE 1
Wireless Power Charger 1. Description Wireless Power Charger System It is electromagnetic induction wireless charging system. Wireless power charger transmits 10W power to mobile. Qi (WPC) certified cell phone, which is a standard for wireless charging, or a case dedicated to wireless charging, can be used this system.
PAGE 2
5. Connector pin description 7. Matching parts Front console or Center console in automobile PIN # Description 1 Ground 2 Ground 3 PWM LED AMBER OUT 4 PWM LED GREEN OUT 5 B-CAN LOW 6 B-CAN HIGH 7 Not connected 8 L-CAN LOW 9 L-CAN HIGH 10 Not connected 11 IGN + 12 BAT + 6. How to use 1) Input IGN+, BAT+ power to Wireless charger by #11, #12 pin on connector. 2) Put mobile which support wireless charging on the wireless charger 3) Check wireless charging connection.
PAGE 3
FCC warning statement: 15.19 λ. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 15.105 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.