Wiring and design guide

2018/08/21 Rev1.2 Quick Installation Guide

YC600-NA Microinverter Quick Installation Guide

Step 1. Verify the grid voltage to match with microinverter rating

Step 2. The AC bus distribution

a. The AC bus is arranged at the proper position of the microinverter.

b. One end of the AC bus access junction box into power grid.

Wire the conductors of the AC bus: L - BLACK; L - RED.

NOTE: Wiring colour code can be different according local regulation, check all the wires of the

installation before connecting to the AC bus to be sure they match.Wrong cabling can damage

irreparably the microinverters, such an issue is not covered by the warranty.

Step 3. Attach the APsystems Microinverters to the racking

NOTE: Do not place the microinverters (including DC and AC connectors) where exposed to the

sun, rain or snow, even gap between modules. Allow a minimum of 3/4’’(1.5cm.) between the roof

and the bottom of the microinverter to allow proper air flow.The racking of install inverter must

be reliably grounding.

a. Mark the location of the microinverter on the rack, with respect to the PV module

junction box or any other obstructions.

b. Mount one microinverter at each of these locations using hardware recommended

by your module racking vendor.when install microinverter, grounding washer Must be facing the

racking.

Step 4. Ground the system.

Step 5.

Connect the APsystems Microinverter to AC bus cable

Push the microinverter AC connector to the trunk cable connector. Listen for the "Click".

Please scan the QR code to get

mobile app and more support

to help the installation.

Click

Best Practice: Use the Bus Cable

Unlock Tool of AC Bus to split

the connectors.

grounding washer

PAGE 1
Please scan the QR code to get mobile app and more support to help the installation. YC600-NA Microinverter Quick Installation Guide Step 1. Verify the grid voltage to match with microinverter rating Step 2. The AC bus distribution a. The AC bus is arranged at the proper position of the microinverter. b. One end of the AC bus access junction box into power grid. c. Wire the conductors of the AC bus: L - BLACK; L - RED.
PAGE 2
NOTE: AC connector interface as follows. NOTE: Cover any unused connectors with Bus Cable Y-CONN Cap to protect the connectors. Step 6. Install a Bus Cable End Cap at the end of AC bus cable a. Strip cable jacket. c. Insert the wires into the cable clamps. b. Insert the cable end into the seal. d. Rotate the nut with 3.3N·m until the latching mechanism meets the base. Nut Seal Body Step 7. Place the PV modules and connect each YC600 to the PV modules Step 8.