Transmitter-PLC User Manual

TRANSMITTER-PLC INSTALLATION
• Mount Transmitter-PLC and power supply on DIN rail
• Connect DC leads from power supply to Transmitter-PLC
• Connect single/dual core(Core 1 and Core 2) to Transmitter-PLC
No
Note: If there is only one core need to connect, please connect Core 1 first.
te: Install RSD-S-PLC before powering on Transmitter.
Place rapid shutdown system label no more than 1m (3ft) from Transmitter or AC
disconnect if not at same location.
T
During operation, the Power LED should be lit and the Signal LED should be blinking.
When Transmitter fails to work, the Signal LED will not be blinking. If the Power
LED is also not lit, check the power supply first.
ransmitter power supply must be on same AC branch circuit as inverter to meet
rapid shutdown requirements.
9
V-V+
N L
V -
C
US
25 90 77
sm art
Power Supply
Transmitter-PLC
Core 1
Core 2
1
2
3
4
Optional power supply
85-264VAC
180-550VAC
1
3
4
Power LED
V+
V -
Core 2
Signal LED
Core 1
2