RSD-D Installation & User Manual

User Manual

RSD-D INSTALLATION

NOTE: When installing RSD-D cable, the bending radius of the cable near the casing must be greater than 50 mm.

Step 3: Connect the output ports of two adjacent RSD-Ds in series and then connect

to the inverter with a self-made DC extension cable.

NOTE: Do not connect homerun to inverter before finishing all strings connections and tests.

WARNING: When connecting the RSD-D to only one PV module, use INPUT1 port ONLY, then short both terminals

of INPUT2 directly or by extension cable, otherwise the RSD-D may be damaged. The DC output voltage remain

same.

NOTE: Please use the same type of DC connector as the RSD in the system. The RSD damage caused by using

different type of DC connector will not be covered by the warranty.