Installation & User Manual

User Manual

TRANSMITTER-PLC INSTALLATION

Transmitter-PLC power supply must be on same AC branch circuit as inverter to meet rapid shutdown

requirements.

During operation, the Power LED should be lit and the Signal LED should be blinking. If the Transmitter-

PLC fails to work, the Signal LED will not be blinking. If the Power LED is also not lit, check the power

supply first.

Note: Install the RSD-D before powering on the Transmitter-PLC.

• Mount Transmitter-PLC and power supply on DIN rail

• Connect DC leads from power supply to Transmitter-PLC

• Connect single/dual core(Core 1 and Core 2) to Transmitter-PLC

Place rapid shutdown system label no more than 1m (3ft) from Transmitter-PLC or AC disconnect if not at

same location.

Note: If there is only one core needed, connect using Core 1 terminal.