Instruction Manual

ManualsBrandsAPS ManualsAirsoftASR M4 Series

HANDLING & INSTRUCTION MANUAL

(For All ASR Model Use)

ASR SERIES

ELECTRIC BLOW BACK GUN

www.airsoftaps.com

WARNING

This Airgun is not intended for

unsupervised used by any persons under

the age of 18 years. Always read the

instructions carefully before operation

Accuracy Pneumatics Shooting

APS Airgun Ltd – gun specialist since 1993

www.airsoftaps.com

Manufacturer by Qian Wei Paintball Support Co. Ltd

Made In China

Please contact your dealer or APS for overhaul

maintenance and technical guidance

Rev$040110$

Summary of content (6 pages)

PAGE 1
HANDLING & INSTRUCTION MANUAL (For All ASR Model Use) ASR SERIES ELECTRIC BLOW BACK GUN Accuracy Pneumatics Shooting APS Airgun Ltd – gun specialist since 1993 www.airsoftaps.com Manufacturer by Qian Wei Paintball Support Co. Ltd Made In China WARNING This Airgun is not intended for unsupervised used by any persons under the age of 18 years. Always read the instructions carefully before operation Please contact your dealer or APS for overhaul maintenance and technical guidance Rev 040110 www.
PAGE 2
1 Warning (Restricted to user under age of 18 years) Always wear goggles or eye protective gear to protect your eyes when shooting Never point the muzzle at people or animals Always keep the airgun out of children reach Disassembling or modifying the gun may affect the gun’s performance and void manufacturer’s warranty Don’t look at the muzzle directly. It is extremely dangerous Remove magazine and battery during storage.
PAGE 3
12 2 ASR Model Layout Structure Rear Sight Front Sight Butt Stock Flash Hider Hand Guard Magazine Release Button Pistol Grip ASR 103 3 300 Rounds Magazine Specification Weight Barrel Length Barrel Caliber Pellet Capacity Pellet ASR101 2.99kg 370mm 6.08mm 300 6mm BB ASR102 2.8kg 300mm 6.08mm 300 6mm BB ASR103 2.83kg 300mm 6.08mm 300 6mm BB ASR104 3.1kg 370mm 6.08mm 300 6mm BB ASR105 2.88kg 300mm 6.08mm 300 6mm BB ASR106 2.5kg 270mm 6.
PAGE 4
12 Filling the Magazine ASR Model BB Bullet Hatch Slide Rib to release excess bullet Exit Magazine Catch 1) Take out the magazine 5 2) Open the magazine hatch cover and Insert 300 rounds 6mm BB bullet 3) Close the magazine hatch cover 4) Turn the gear wheel until the click click sounds change Turn the gear wheel anticlockwise only Install Battery ASR 101 Delta Ring Flash Hider Locking plate Pull back the delta Ring and take down the hand guard Connect the collectors Pull back the delta Ri
PAGE 5
11 6 Troubleshooting Guide Status No operation at all Although the motor is running, but no BB fire out Cause Action Fire selector is set to Safe Set the fires selector to Semi or Full Auto Battery is not charged Fully charge the battery Battery connector is disconnected or reversed Fuse is fall off or blown down Connect the connector correctly Poor Motor electrical connection Check and repair the motor Expired Motor Life Replace a new motor Magazine is not full seated into the receiver Lo
PAGE 6
8 Hop Up Adjustment (Suitable for ALL ASR Mode) 9 Dissembling the gun Too Much Hop Up (Return lever towards NORMAL) Best Position Not Enough Hop Up (Move lever towards HOP) Variable Hop Up System By producing backspin on the BB bullets, this system allows BB to fly straighter and longer Remove the frame lock pin using a screw driver Move the upper receiver forward Separate the upper and lower receiver (beware of the wire) Pull the charging handle and open the ejection cover.