Instruction Manual

$
Hop"Up"Adjustment"(Suitable"for"AL L"ASK"M ode)"
8"
Too Much Hop Up (Return lever towards NORMAL)
Best Position
Not Enough Hop Up
(Move lever towards HOP)
Adjustment Lever
NORMAL
HOP
Variable Hop Up System
By producing backspin on the
BB bullets, this system allows
BB to fly straighter and longer
• The best position is where the bullets fly horizontally and the longest flying distance is
obtained.
• Turning excessively adversely affects the trajectory. Therefore stop turning the dial when
bullets fly horizontally.
• Moving the lever too much towards HOP will cause bullets to clog. Firing the gun with
clogged bullets will damage the piston and gear.
• If the hop up is adjusted excessively and causing clogging of bullets, stop operating the
gun immediately. Return the lever to NORMAL and remove the clogged bullet.
• APS Airgun Ltd will not be held responsible for any damages or accidents causing by
wrongful operation, disassembly and modification of the airgun.
Caution
Maintenance (Removing Clogged Bullets & Barrel Cleaning)
10"
1. Make sure to insert the cleaning rod AFTER returning the hop up lever to NORMAL
position. (HOP OFF)
2. Insert the cleaning rod from the lead edge of the barrel
3. Be careful so that the angled part of the cleaning rod facing down and remove clogged
bullets
Insert the
cleaning
rod
Cleaning Rod facing down
Wrap the rod
Maintenance is needed when bullet speed becomes slow. Wrap a cotton cloth on the rod. Hold the
leading end of the rod and insert rod into the barrel while turning the rod to clean the barrel inside
Dissembling the hand guard
9"
1. Push the upper hand guard
fixer upwards
2. Push the upper hand guard
towards the muzzle and
take the whole upper hand
guard up by pulling it
upwards
3. Take away the Dummy
Cleaning Rod (Optional)
4. Press down the button of
lower hand guard ring.
5. Push the lower hang guard
rings towards the muzzle
6. Push down the lower hand
guard and take it off from
the guns
1
2
3
4
5
6