Instruction Manual

Troubleshooting Guide
11"
Sight Adjustment
6"
Firing Operation
7"
Safe
To Fire the pellet
1) Switch the selector switch to Semi or Full Auto
2) Pull the trigger
Caution
Semi Auto
• Confirm your firing area is safe before firing.
• There are possibilities that no BB comes out after pulling the trigger. This may
happen when new magazine is inserted. Switch to Full Auto and fire 5 – 10 shots will
solve this problem.
• Charge the battery if the firing cycle become slow.
• Give the airgun a rest of 5 – 10 minutes after firing 220 rounds in order to ensure long
service lives of the motor and battery.
• If bullets are clogged, stop firing and remove the clogged bullets immediately.
• Service the airgun with silicon oil as daily maintenance.
• Hop up may be unstable for first 200-300 rounds after silicon oil is used, this is
normal operation of the gun.
Press
Press the adjust button and slide it forward
or backward. The larger the number, the
longer the distance to the target
Long Distance
Short Distance
Sight
Front Sight: Adjust the sight clockwise for
higher sight point or anti-clockwise for lower
sight point
Status
Cause
Action
Fire selector is set to Safe
Set the fires selector to Semi or Full Auto
Battery is not charged
Fully charge the battery
Battery connector is disconnected or
reversed
Connect the connector correctly
Fuse is fall off or blown down
Replace the fuse
Poor Motor electrical connection
Check and repair the motor
No operation at all
Expired Motor Life
Replace a new motor
Magazine is not full seated into the
receiver
Load the magazine into receiver and turn
the gear wheel. If still doesn’t work,
contact your service technician or ask us
for assistance
Bullets are clogged in Hop up system or
barrel
Using the cleaning rod to remove clogged
bullets
Faulty gear
Although the motor is
running, but no BB fire
out
Tappet plate is broken
Please contact your service technician or
ask us for assistance
Insufficient battery power
Charge the battery
Full auto not
functioning
Fault bullets feed from magazine
Using the cleaning rod to remove clogged
bullets
Deviation in gear timing
Fire 5-6 rounds in full auto then switch
back to semi auto again
Insufficient battery power
Charge the battery
Semi auto not
functioning
Fault bullets feed from magazine
Using the cleaning rod to remove clogged
bullets
Hop up or barrel damaged
Please contact your service technician or
ask us for assistance
BB roll out from barrel
Faulty or poor quality of BB
Use higher quality BB
Hop up or barrel damaged
Piston or O-ring damaged
Deteriorated piston spring
Gear problem caused by excessive dry
firing
Shooting distance
greatly reduced
Faulty BB Bullets
Please contact your service technician or
ask us for assistance
Damaged dear
Please contact your service technician or
ask us for assistance
Loud operation noise
Problem caused by engagement between
the motor and gears
Don’t tune the engagement between the
motor and bevel gear yourself, contact
your service technician or ask us for
assistance
Gun has been
immersed by water
Stop Operation immediately and disconnect the battery. Wipe off any excess water
from inside the body and from the battery. When AEG is completely dry, test fire. If no
operation or signs of malfunction is suspected, please contact your service technician
or ask us for assistance
$
Full Auto