Assembly Instructions

32 / 36
The reproduction, distribution and utilization of this document as well as the communication of its contents
to others without express authorization is prohibited. Offenders will be held liable for the payment of damages.
All rights reserved in the event of the grant of patent, utility model or design.
02.06.2022
Version 1.0
Appendix
APS-90-Lite
A
Accessories
The APS-90-Lite is mechanically identical to the APS-B. Therefore, the accessories of the
APS-B can also be used for the APS-90-Lite.
Accessory Description Orde
r
r no.
APS-B variable mounting kit Installation kit for recessed mounting
with adjustable angle between 0 and 90
degree
226.169-107
APS-B flush mounting kit Installation kit for flush mounting 226.169-007
APS-B surface mounting kit Installation kit for surface mounting 226.169-207
APS-B connection cable 2m (6.5 feet) Assembled 8-pin cable with connector 226.172-007
8.2 Federal Communications Commission (FCC) Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
ࡇ This device may not cause harmful interference, and
ࡇ This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
ࡇ Reorient or relocate the receiving antenna.
ࡇ Increase the separation between the equipment and receiver.
ࡇ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
ࡇ Consult the dealer or an experienced radio/TV technician for help.
To assure compliance, a shielded Ethernet cable shall be used for connection. Any
changes or modifications of the device not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.