Assembly Instructions

12 / 36
The reproduction, distribution and utilization of this document as well as the communication of its contents
to others without express authorization is prohibited. Offenders will be held liable for the payment of damages.
All rights reserved in the event of the grant of patent, utility model or design.
02.06.2022
Version 1.0
Hardware
APS-90-Lite
Fig. 4: Mini-Fit I/O Interface
("A": optics orientation)
3.3 I/O Port on Device
P
Pi
n
n no. Name Description
1 PWR + DC voltage supply +
(12 ... 30 V)
2 IN1 + Programmable input +, potential-free
(typically used for a door contact)
3 IN2 + Programmable input +, potential-free
(typically used for a door contact)
4 OUT1 + Programmable output +, potential-free
5 GND DC voltage supply -
6 IN1 - Programmable input -, potential-free
(typically used for a door contact)
7 IN2 - Programmable input -, potential-free
(typically used for a door contact)
8 OUT1 - Programmable output -, potential-free
3.4 Status LED
Statu
s
s LED
Starting the device takes about 40 seconds. During this time the status LED is as follows:
ࡇ When the device starts the LED is illuminated in red for approximately 5 sec.
When the device starts the LED is illuminated in red for approximately 10 sec.
ࡇ During the rest of the startup process the LED flashes green.
ࡇ While waiting for DHCP the LED is blinking in yellow. This overlays the green blinking
of startup process.
ࡇ At end of startup the LED is illuminated in green for approximately 6 sec. Then off.
User interface is accessible approximately 10 sec later.