User`s guide

Apriva

BT200-T Device Utility for RIM

Mobile Devices Installation and User’s Guide

Identifying the Smart Card

Identifying the smart card verifies that the Personnel applet and PKI are

present. If you receive an error, such as “Smart Card not present” or “Smart

Card not found” while attempting to identify the smart card, make sure the

smart card is placed in the reader as shown in the example in Apriva Reader

Features on page 4. If you still receive an error message, you must log in to

the mobile device with the smart card PIN. Then exit the Apriva Device Utility,

power cycle the reader, and perform the operation again.

To identify the smart card:

1. During the session, either use the trackpad to scroll to Smart Card

Identification or press the lowercase i on the keyboard.

2. Press the trackpad to select the option. The smart card verification

information appears. If the screen shows “No Smart Card Reader

Session. Session is not open,” the smart card is not identified by the

mobile device. If the mobile device displays this message, you must log

on to the device using your smart card pin before the mobile device can

identify the smart card.

Figure 14 – Open Session message

Closing a Reader Session

After you have identified the smart card, close the reader session to complete

the test.

To close a reader session:

1. During the session, either use the trackpad to scroll to Smart Card

Close Session or press the lowercase d on the keyboard.

2. Press the trackpad to select the option. The screen shows “Smart Card

Closed Session.”