User`s guide

Apriva

BT200-T Device Utility for RIM

Mobile Devices Installation and User’s Guide

Powering on the Reader

When powered on, both LEDs illuminate while the reader performs a series of

startup tests. For LED startup descriptions, see Reader LED Startup

Indications on page 24.

To power the reader on or off:

Press the Power On/Off button on the top of the reader. If the reader will

not power on (the LEDs are not lit), try charging the battery as described

in Charging a Completely Discharged Reader Battery on page 24.

Downloading the Apriva Reader

Driver

You must download the Apriva reader driver from the Apriva Support website

before you can install it on the mobile device. See below.

To download the Apriva reader driver:

1. Go to the Apriva Support website at

http://iss.apriva.com/support_rim_drivers.aspx.

2. Download the driver (Zip file) for your RIM operating system version. For

version compatibility information, see RIM OS – S/MIME – Apriva Device

Utility Requirements page 3.

3. Save the Zip file to a folder that you will keep on your computer.

4. Unzip (extract) the Zip file. After unzipping the file, the following files

should be in the folder (see Figure 2):

• The Zip file with the version number

• AprivaDeviceUtility.alx

• AprivaDeviceUtility.cod

• AprivaSmartReader.cod

• AprivaSmartReaderLibrary.cod

• Readme.txt

Figure 2 – Apriva Device Utility files