User`s guide

Table Of Contents

Apriva

BT200-T Smart Card Reader for Windows Mobile

Version 6.x Installation and User’s Guide

To charge the reader battery:

Connect the USB cable from the PC/CHARGE port on the reader to the

USB port on the computer or a standard wall charger. Allow the battery

to charge for 20 to 30 minutes. When charging, the GREEN LED is

continuously lit with occasional quick flashes.

Charging Indications

Table 2 shows reader LED charging indications. For general LED operation

descriptions, see Reader LED Descriptions on page 15.

Indication Description

GREEN LED is continuously lit with

occasional quick flashes.

The reader is connected to a computer

and the battery is charging.

GREEN LED is not continuously lit but

blinks on every few seconds.

The reader has a sufficient charge.

RED LED is continuously lit. The battery is low and needs to be

charged.

Table 2 – LED Charging indications

Installing the Reader USB Driver

If you are using a USB connection to charge the battery (not a wall charger),

and the battery does not seem to be charging, or if it takes more than one hour

to charge, you might need to install the Apriva USB driver.

To install the USB driver and recharge the reader:

1. Download the USB driver from the Apriva downloads website. For driver

download information, see Apriva Technical Support on page 17.

2. Connect the reader to the computer with the USB cable to start the driver

installation wizard.

3. Follow the wizard instructions to install the USB driver.

After installing the driver, connect the reader to the computer with the USB

cable to charge the reader.