User`s guide
Table Of Contents
- Front Cover
- Title Page
- Notice
- Contents
- Figures
- Tables
- Introduction
- Apriva BT200-T Reader
- Support
- Back Cover

Apriva
®
BT200-T Smart Card Reader for Windows Mobile
®
Version 6.x Installation and User’s Guide
© Copyright 2010 Apriva. Page 9 September 2010
Charging the Reader Battery
The reader battery must be fully charged before use. It takes approximately
three hours to charge a completely discharged battery. The LEDs on the top of
the reader indicate the charge status. See Charging Indications on page 10.
NOTICE
If you are charging the battery with a computer that uses Windows XP, you
must first install the Apriva USB driver. Failure to do so could drain the
reader battery. See Installing the Reader USB Driver on page 10.
You cannot charge the reader battery with computers that use Windows
Vista or Windows 7 operating systems. If your computer has one of these
operating systems, you must use a wall charger to charge the battery.
To keep the reader functioning properly, make sure the battery level is
always at least 50%. If the reader battery is completely discharged (LEDs
do not illuminate when reader is powered on), charge the reader battery as
described in Charging a Completely Discharged Reader Battery on page 14.
To view the battery voltage:
1. From the mobile device applications menu, select the Apriva Reader
icon ( ). The Apriva Smart Card Reader screen appears.
2. Select the Power tab. The Battery Level area shows the charge
percentage and voltage. See Figure 4. A fully charged battery measures
between 4.1 and 4.2 volts.
Figure 4 – Battery Level area