User`s guide

Apriva

BT200-T Smart Card Reader for Intermec

CK61B/G Installation and User’s Guide

Using Tethered USB Mode

You can disable Bluetooth (wireless) mode and use the reader in tethered

USB mode. Tethered USB mode prevents wireless RF emissions. This is

useful in situations where RF emissions are not allowed, such as airplanes or

Sensitive Compartmented Information Facilities (SCIFs).

NOTE: The devices must be paired before you can switch between USB and

Bluetooth modes. See Pairing the Devices on page 7.

Switching to Tethered USB Mode

If you are currently using the reader in Bluetooth mode, you can switch to USB

mode.

To enable USB mode:

1. Connect the USB cable to the PDA port on the reader, and then connect

the other end of the USB cable to the mobile device. Use the supplied

USB adapter if necessary.

2. Make sure the smart card is inserted in the reader, and then press the

ON/OFF switch to power on the reader.

3. From the mobile device applications menu, select the Apriva Reader

icon ( ). The Apriva Smart Card Reader screen appears.

4. In the Reader Connection area, select USB. Do not select Enhanced

USB.

5. Select Test Connection to verify that the USB connection is working.

Switching to Bluetooth Mode

If you are currently using the reader in USB mode, you can switch to Bluetooth

mode.

To enable Bluetooth mode:

1. Make sure the USB cable is connected to the reader.

2. Make sure the smart card is inserted in the reader, and then press the

ON/OFF switch to power on the reader.

3. From the mobile device applications menu, select the Apriva Reader

icon ( ). The Apriva Smart Card Reader screen appears.

4. In the Reader Connection area, select Bluetooth.

5. Remove the USB cable.

6. Select Test Connection to verify that the Bluetooth connection is

working.