User`s guide

Apriva
®
BT200-T Smart Card Reader for Intermec
®
CK61B/G Installation and User’s Guide
© Copyright 2010 Apriva Page 8 September 2010
If the test is successful, the reader is now paired for wireless
operation. When the reader is powered on and the smart card is
inserted, the reader is available for Bluetooth operation. When the
smart card is removed or when you power it off, radio frequency (RF)
emissions stop and the reader is disabled.
If the test fails, try the following, and then retest the connection:
o Check the cables and make sure they are in the correct ports on
device. See Apriva Reader Features on page 3.
o Make sure that the reader battery is charged. See Charging the
Reader Battery on page 10.
Contact Apriva Support if the problem persists. See Apriva Technical
Support on page 29.