User`s guide

Apriva

BT200-T Smart Card Reader for Intermec

CK61B/G Installation and User’s Guide

Pairing the Devices

Pairing the reader (and smart card) to the mobile device creates a one-to-one

connection between the devices.

To pair with the reader to the mobile device:

1. Connect the USB cable to the PDA port on the reader, and then connect

the other end of the USB cable to the mobile device. Use the supplied

USB adapter if necessary.

2. Press the ON/OFF switch to power on the reader.

3. Insert the smart card in the reader.

4. From the mobile device applications menu, select the Apriva Reader

icon ( ). The Apriva Smart Card Reader screen appears. See Figure 4.

If you do not see the Apriva Reader icon, you might need to reinstall the

software. See Installing the Reader Driver on the Mobile Device on

page 4.

Figure 4 – Reader Connection area

5. Select Test Connection to make sure the devices are connected.

6. In the Reader Connection area, select USB. DO NOT select Enhanced

USB. This feature is reserved for future Apriva Reader versions.

7. Select Pair. After pairing, the “Pairing Complete” message appears.

8. Select ok to close the message box.

9. In the Reader Connection area, select Bluetooth to enable the

(wireless) Bluetooth connection.

10. Disconnect the USB cable.

11. Select Test Connection to make sure the devices are connected

through Bluetooth.