Technical data

Aprilia Consumer Service Spa
Technical Service and Training
Release 4 july 99
This material is didactic and
may be changed following the technical
development of the product
ONNECTORS:
The control unit is connected to the electrical circuit by plug-in connectors that plug into the ECU
printed circuit.
The connectors connect the control unit to the sensors and actuators (injectors, coils) via the
wiring.
Also, most of the connected components can be tested via the connectors, using any type of good
quality ohmic tester.
As detailed in the wiring diagram, the connectors refer to the specific components shown in the
figure:
26 WAY CONNECTOR
16 WAY CONNECTOR
IDENTIFICAZIONE
TERMINALI ECU