Installation Manual

CHECK THE DRAIN
The drain and drain pan cover should be checked annually to ensure there are no blockages or air lock in the drain system�
IMPORTANT! The drain cover is a critical feature of the dehumidifier drain management system� This component is required for the dehumidifier to
run properly� If the drain cover is not installed, you will not be able to reinstall the air filter� The air filter is equipped with a safety mechanism that
prevents you from fully inserting the filter without the drain cover installed�
WARNING
Running the dehumidifier without the drain cover can lead to condensate leaks.
REMOVING THE DRAIN PAN COVER
1. Turn the ON/OFF switch OFF�
2. Remove the filter access door from the drain side of the dehumidifier�
3. Remove the filter from the dehumidifier to access the drain cover�
4. Locate the drain cover which is located over the drain opening�
5. Remove the drain cover by hooking your finger into the finger loop and gently lifting the cover up and out of the drain pan�
6. Clean the drain cover with warm water and mild detergent solution�
REINSTALLING THE DRAIN COVER
1. Reinstall the drain cover by inserting your forefinger into the finger loop and grasping the outer edge of the finger loop with your thumb�
2. Gently insert the drain cover tip into the drain opening and tilt the cover downwards into place�
3. Insure the drain cover is seated properly by checking the top surface of the drain cover is the same surface height as the filter guide channel�
4. Turn the ON/OFF switch ON�
5. At the UI control, select the ON/OFF button and switch to ON mode�
CAUTION
Do not use spray solvents or cleaners on or near the inlet side of the dehumidifier.
If desired, apply cleaner to a cloth and use to clean the cabinet.
DRAIN INSERT
90-2607
FIGURE 8 – DRAIN INSERT
8 English