Installation Guide

5 English
CLEANING THE DRAIN
1. With the filter door on the drain side of the
dehumidifier removed, reach in and pull out the
drain insert using the finger loop
(see Figure 6) .
1
90-2607
Figure 6: Drain Cleaning
1 - Drain Insert
2. Clean the drain pan and drain insert using a mild
detergent.
3. If the drain has a capped tee or elbow to allow
cleaner to be poured directly in the drain, remove
the cap and pour approximately one cup of
vinegar into the tube
(see Figure 7) . If there is no
visible access to the drain line from outside of
the dehumidifier, pour approximately one cup of
vinegar into the drain pan of the dehumidifier where
the drain insert was located.
4. Reinstall the drain insert by gently placing the
tip into the drain opening and rocking the insert
downwards into place. When inserted properly, the
top of the drain insert will be at the same height as
the filter guide channel.
5. If the dehumidifier has clear flexible drain tubing,
look for excess buildup in the drain line that might
prevent water flow, and replace as needed. Clear,
smooth, flexible 3/4" inner diameter (ID) drain tubing
is available in most hardware stores or Do-It-
Yourself (DIY) retail stores.
NOTICE
Running the dehumidier without the drain insert can
lead to condensate leaks.
OTE: N Drain insert must be installed before operationg.
2
1
90-2693
Figure 7: Capped Drain Access for Cleaning Process
1 - Cap 2 - Condensate
Drain Line