Install Instructions
CONTROL
PANEL COVER
CONTROL
CONTROL
CONTROL
PANEL COVER
FILTER ACCESS DOOR
CONTROL LOCATION
The on-board control can be located on the top of
the dehumidifier or can be relocated to the front
of the dehumidifier if the control cannot be seen/
accessed in the top orientation. It may also be
rotated 180 degrees in either orientation as shown
in Figure 5.
To move the control:
1. Remove the top control panel cover.
2. Remove the filter access door and filter.
3. Detach the on-board control by removing the four
(4) screws around the control. NOTE: Use one
hand to support the back of the on-board control
when removing.
4. Keep the control in the unit and relocate to the
top access hole.
5. Secure the control with the same four screws
used to attach the control to the front of the unit.
6. Secure the control panel cover to the front of the
unit.
FIGURE 4 – Control Location
90-1884
Use the screws in the parts bag to attach the duct collars to the
inlet and outlet of the dehumidifier. The outlet collar has a backflow
damper. See Figure 3.
OUTLET COVER
OUTLET DUCT
COLLAR W/BACK
DRAFT DAMPER
INLET
DUCT
COLLAR
END DISCHARGE
FIGURE 3 – Install Duct Collars
90-1909
DUCT COLLARS
90-2525
FIGURE 5 – Control Rotated 180 Degrees
4