Install Instructions

CLIP OFF
PLASTIC
STRAP
REMOVE SHIPPING BRACKET
FLOAT
Switch
ALERT
ALERT
LIGHT
+ –
AB
FIGURE 1 – Remove Shipping Bracket FIGURE 2 – Float Switch and Alert Light Wiring
90-1908
90-1948
IMPORTANT: Cut the strap securing the compressor shipping support bracket and remove the strap and shipping bracket.
See Figure 1.
IMPORTANT: Remove the ALERT LIGHT and FLOAT Switch cables from around the duct collar.
Remove the wire access cover. Plug the 4-terminal block
connected to the ALERT LIGHT cable into the pins labeled
+
– A B and the remaining 2-terminal block from the cable
into the pins labeled ALERT. See Figure 2.
SET UP DEHUMIDIFIER FOR INSTALLATION
1. Dehumidifier
2. Inlet/Outlet Collars
3. Literature
a. Installation Instructions
b. Owner’s Manual
4. Parts Bag
a. #8 x 3/8 Screw (1)
b. #10 x 1/2 Screws (9)
c. Wire Nut (2)
d. Bracket for Alert Light (1)
e. Plastic Staples (6)
f. Barbed Fitting & Reducer for Drain Connections
g. Torx Bit
PACKAGING CONTENT
3