Use and Care Manual

MAINTENANCE

CLEAN OR REPLACE THE AIR FILTER

After initial installation the air filter should be checked and cleaned every 6 months. The CLEAN

FILTER service reminder will display on the on-board control screen every 6 months. To clear the

service message, press the UP and DOWN arrows simultaneously for 3 seconds.

Filter Cleaning Procedure

1. Turn the ON/OFF switch OFF.

2. Remove the filter access door from either side of the dehumidifier.

3. Slide the filter out of the dehumidifier.

4. Flush the filter with warm water and a mild detergent solution.

5. Shake off the excess water from the filter.

6. Replace the filter, making sure the filter is secured in both the top and bottom filter rails.

7. Replace the filter access door.

8. Turn the ON/OFF switch ON.

9. Press the UP and DOWN buttons simultaneously for 3 seconds to clear the service message.

90-1854

CAUTION

Do not use spray solvents or cleaners on or near the inlet side of the dehumidiﬁer.

If desired, apply cleaner to a cloth and use to clean the cabinet.

CHECK THE DRAIN

DIAGNOSTIC CODES

The drain should be checked annually to ensure there are no blockages or air lock in the drain system. If the unit is not draining properly, have it

checked by a qualified service professional.

The on-board control will display a diagnostic code if an error should occur and service is required.

Contact your installing contractor if E1– E7 or E9 is displayed on the on-board control screen. E8 will be

displayed if the incoming air temperature is below 50°F, above 104°F, or when the dew point is below

40°F. When the incoming air is within the acceptable range, the dehumidifier will resume operation.

If the error persists, contact your installing contractor.

TROUBLESHOOTING

90-1854