Install Instructions

TABLE 4: THERMOSTAT SYSTEM SETTINGS
System Setting Description
Factory Default Settings (bold)
and Settings Range
Equipment Type Note: Equipment Type related settings will return to defaults if this is changed.
Heat/Cool
Heat Pump
Control Setup Used to lockout heating or cooling outputs. (Heat/Cool mode only.)
Heat & Cool
Heat Only
Cool Only
Heat Pump Auxiliary Type Selects auxiliary type. (Heat Pump mode only.)
Gas/Oil Heat
Electric Heat
Fan Control In Heating
Selects thermostat or equipment to control the fan in heating. (Heat/Cool mode
only.)
Gas/Oil Heat
Electric Heat
Number of Compressor Stages Select number of compressor stages. (Heat Pump mode only.)
One
Two
Number of Auxiliary Heat Stages Select number of auxiliary heat stages. (Heat Pump mode only.)
One
Two
Number of Stages of Heat Select number of heat stages. (Heat/Cool mode only.)
One
Two
Number of Stages of Cool Select number of cool stages. (Heat/Cool mode only.)
One
Two
Return Air Temperature Sensor Installed? Select whether return air temperature sensor is attached or not.
No
Yes
Outdoor Temperature Sensor Installed? Select whether outdoor sensor is attached or not.
Yes
No
Automation
Schedule Zone 1 Enables or disables programmable schedule. Note: Disabled if Automation.
Enabled
Disabled
Schedule Zone 2 Enables or disables programmable schedule. Note: Disabled if Automation.
Enabled
Disabled
Schedule Zone 3 Enables or disables programmable schedule. Note: Disabled if Automation.
Enabled
Disabled
Progressive Recovery Enables or disables progressive recovery.
Enabled
Disabled
Display Away Button?
Away allows the user to set the thermostat to a predefined setpoint using
a single button press. The predefined setpoints can be selected in the User
Settings.
Yes
No
Display Heat Blast Button? Select whether the Heat Blast button is displayed.
Yes
No
Blast Offset Amount of heating when Heat Blast is initiated.
3°F (1.5°C)
4°F (2°C)
5°F (2.5°C)
Extended Fan – Heat Extends fan operation after heat call ends.
Disabled
Enabled
Extended Fan – Cool Extends fan operation after cool call ends.
Disabled
Enabled
Auto Changeover Enable or disable Auto Changeover mode.
Enabled
Disabled
DeadBand Auto Changeover mode deadband.
3°F (1.5°C)
2 to 9°F (1 to 4.5°C)
Auto Changeover Time Minimum time between heating and cooling calls.
4 Minutes
1 to 5 Minutes
Temp Sensor Offset Zone 1 Field adjustment of controlling temperature sensors.
0°F (0°C)
-4 to 4°F (-2 to +2°C)
16