Install Instructions

WIRING

WIRE SPECIFICATIONS:

18-24 gauge thermostat wire

INSTALLATION NOTES:

Control to Hub

• Ensure power at the 6000 Series Hub is off.

• Insert stripped wire (Hub).

• Loosen screw terminals (Control), insert stripped wire and re-tighten.

• Push the excess wire at Control, back into the opening and plug the

wall opening to prevent drafts.

1 – Connect Control terminal 1 to Hub terminal 1

2 – Connect Control terminal 2 to Hub terminal 2

3 – Connect Control terminal 3 to Hub terminal 3

4 – Connect Control terminal 4 to Hub terminal 4

Sensor to Hub

• Ensure power at the 6000 Series Hub is off.

• Insert stripped wire (Sensor & Hub).

• Push the excess wire at Sensor, back into the opening and plug the

wall opening to prevent drafts.

1 – Connect Sensor terminal 1 to Hub terminal 1

2 – Connect Sensor terminal 2 to Hub terminal 2

3 – Connect Sensor terminal 3 to Hub terminal 3

4 – Connect Sensor terminal 4 to Hub terminal 4

90-2423

90-2424

FIGURE 21 – 4-WIRE CONNECTION, 6000 SERIES CONTROL

FIGURE 22 – 4-WIRE CONNECTION, 6000 SERIES SENSOR