Install Instructions

LOCATION CONSIDERATIONS

TOP VIEW

FILTER

MINIMUM

CLEARANCE FOR FILTER

(EITHER SIDE)

20"

6" MINIMUM CLEARANCE

FOR PROPER AIR FLOW

ELECTRICAL SERVICE

ACCESS THIS SIDE

6 FT. POWER CORD

FIGURE 2 – Filter Access Clearance

90-2042

• Allow sufficient clearance for filter removal and

to prevent airflow obstruction

• Electrical service access will require the removal

of the side panel shown. Allow sufficient space

for service on this side of the unit.

• If locating the unit in an attic or crawl space, a

Model 76 Control mounted in the living space

is recommended. Refer to Model 76 Installation

Instructions and Owner’s Manual.

• Always install the dehumidifier in a condensate

pan when locating in or over a finished space.

CUT OFF

PLASTIC STRAP

REMOVE SHIPPING BRACKET

FIGURE 1 – Remove Shipping Bracket

90-2040

IMPORTANT: Cut the strap securing the compressor

shipping support bracket and remove the strap, shipping bracket

screws, and bracket. See Figure 1.

SET UP DEHUMIDIFIER FOR INSTALLATION