Install Instructions

SYSTEM SET-UP, CHECK & START-UP
If using a Model 76 Remote Control and/or the Air Cycling feature,
proceed to Step 1 below. If not using either feature, proceed to
SYSTEM CHECK on page 7.
1. Check all wiring.
2. Make sure the wire access cover has been snapped back onto the
on-board control.
3. Plug unit in and turn power switch to ON. The power switch is
located on the dehumidifier outlet next to the power cord.
4. The on-board control screen should display OFF.
90-1854
NOTE: If the display backlight is not on, the first button press (any
button) will only turn on the backlight. Press the button a second time
to achieve function.
5. Hold the MODE button on the on-board control for 3 seconds to
enter the Installer Set-up Menu.
6. Navigate through the following screens to set up the dehumidifier
for the installed application.
Use the UP or DOWN arrows to select items and use MODE to
switch to the next set-up option. To exit installer set-up, all options
must be scrolled through using the MODE button.
7. After the installer set up options have been completed, DONE will
blink for 3 seconds and the control will return to the OFF screen.
90-1854
90-1854
REMOTE CONTROL – CRAWL SPACE
90-1854
If not installing in a crawl space
with Model 76 remote control,
press MODE to go to VENT screen
selections
90-1854
If installing in a crawl space with
remote control, Enable and press
MODE. The installer set-up is
complete, proceed to SYSTEM
CHECK on page 7.
NOTE: Air Cycling is not an
option when Remote is enabled.
6