Technical information

LS PRO OWNER'S HANDBOOK 7/3
Using PCMCIA Cards
Chapter 7
Inserting a card
1. Check what type of card you have.
If it is a Type I or Type II card, you can use either Slot␣ 1
or Slot␣ 2. If it is a Type III card, you should use Slot 1.
2. Align the card with the chosen slot. The card should
be inserted face uppermost.
Some cards have arrows or wording on them to
indicate which way up they should be. Check the card’s
documentation if you are unsure.
3. Slide the card into the slot until the connector on the
card engages with the socket.
This is designed to be a tight fit so a slight pressure
may be required to engage the card. When the slot’s
eject button pops out, the card is seated correctly.
Caution
Do not use excessive force. If the card does not seem to fit it is
probably upside down.
Removing a card
To remove a card:
1. Press the eject button next to the slot.
The eject button for Slot 1 is on the left of the slot;
the button for Slot 2 is on the right. The card is
disengaged from the socket and partially ejected.
2. Remove the card completely.