Technical information

9/8 LS PRO OWNER'S HANDBOOK
Upgrading
Chapter 9
If the upgrade processor is not big enough to occupy
all four rows of holes in the socket it should be
positioned centrally as shown below.
POSITIONING
GUIDE
KEYED
CORNER
UNOCCUPIED
HOLES ON
EACH SIDE
PROCESSOR
CENTRED
IN SOCKET
Caution
If the processor is misaligned it will not go into the socket,
and any attempt to force it will damage the processor, or
the socket, or both.
4. Move the securing lever to the locked position. Apply
just enough pressure to overcome the resistance
offered by the lever.
5. You may need to adjust some jumper settings on the
motherboard:
If you have replaced an Intel486␣ SX processor with
any other type, you must move the Processor
Selection jumper from “SX” to “Other”.
If the new processor has a different external clock
speed than the one it replaced, you must move the
Speed Selection jumper.