User Guide

www.apricorn.com 9
3. CONNECTING YOUR EZ BUS DTS
It is very simple to set up your EZ Bus DTS connection:
1. Start by turning off your computer.
Caution: Never connect or disconnect your EZ Bus DTS while your computer
is powered on.
2. Depending on the type of port (SATA or eSATA) your computer has choose
the appropriate SATA cable.
3. Now connect the SATA end of the cable to the SATA port at the rear of the
EZ Bus DTS and the other end to an available (SATA or eSATA) port on your
computer.
4. Connect the AC adapter at the rear of the EZ Bus DTS and then plug into
an available wall outlet or power strip.
5. Push the on switch located on the front of the EZ Bus DTS. The indicator
light will come on to let you know that the EZ Bus DTS is powered.
6. Now, power up your computer.
Caution: Never connect or disconnect your EZ Bus DTS while
your computer is powered on.