User Manual

Changing the Admin PIN

Changes to the Admin PIN can only be made while the drive is in the Admin mode.

1. Enter the Admin mode. (Hold + 0 for ve seconds – with the RED LED blinking, enter

the Admin PIN and press the button.) The BLUE LED will glow steadily.

2. Press UNLOCK + 9. The BLUE LED will glow steadily and the GREEN LED will blink.

3. Enter the new Admin PIN and press the button. The GREEN LED will blink

three times.

4. Re-enter the new Admin PIN and press the button. The GREEN LED will glow steadily

for two seconds and then return to the Admin mode, indicated by the BLUE LED glowing

steadily.

Deleting the User PIN

You can delete the User PIN by doing the following:

1. Enter the Admin mode. (Hold + 0 for ve seconds. With the RED LED blinking, enter the

Admin PIN and press the button.) The BLUE LED will now glow steadily.

2. Press the 7 + 8 buttons together for ve seconds. The GREEN LED will blink three times and

then will be followed by the RED and BLUE LEDs blinking alternately.

3. Press the 7 + 8 buttons together again for ve seconds. The GREEN LED will glow

steadily for two seconds.

4. The drive will return to Admin mode indicated by the BLUE LED glowing steadily.

NOTE: Deleting the User PIN will also delete the Self-Destruct PIN and all recovery

PINs (if any have been set.)

Changing the User PIN

The User PIN can be changed within the User mode (drive unlocked, GREEN LED blinking)

*Note: The Admin PIN cannot be changed while in the User mode. The Admin PIN can only

be changed from within the Admin mode-- See below.

You can change the User PIN by doing the following:

1. Unlock the Aegis Padlock DT with the User PIN. (The GREEN LED will blink)

2. Press the + 1 buttons together for ve seconds (the RED LED will blink)

3. Enter the current User PIN and press the button. (The BLUE LED will glow steadily

and the GREEN LED will blink.)

4. Enter the new User PIN and press the button (the GREEN LED will blink three

times, followed by the BLUE LED glowing steadily and the GREEN LED blinking.)

5. Re-enter the new User PIN and press the button (the GREEN LED will glow

steadily for two seconds, then will return to the User mode, indicated by the GREEN

LED blinking.)