User guide

www.apricorn.com 7
2. HARD DRIVE INSTALLATION
Aegis Desktop Kit hard disk drive installation instructions (the kit is shipped
without a Serial ATA hard disk drive). If you purchased an Aegis Desktop with a
hard drive already installed, please proceed to page 9.
Please follow the steps as below for installing your HDD into the Aegis Desktop
enclosure.
1. With the logo side of the drive
down, remove the rubber pads
and screws.
2. Gently lift off the cover to
expose the existing hard drive.
(upgrade only) skip to step 5 if
you are installing a new disk.
WARNING: DO NOT TURN CASE UPSIDEDOWN ONCE THE COVER HAS BEEN
REMOVED AND THE HARD DRIVE IS STILL CONNECTED.
3. Lay the case on a at surface and slide the hard drive completely away from
the connector before gently lift it out of the case.
Slide the HDD