User`s guide

300Mbps Wireless N USB Adapter – APPUSB300 User’s Guide English

Chapter 2. Installation Guide

2.1 Hardware Installation

There are two ways to install the Adapter:

1. Plug the Adapter directly to the USB port on your computer.

2. Connect the Adapter and your computer through the USB cable attached in package.

The LED will light up when the Adapter is installed successfully and the PC is on.



Note:

The promoted Found New Hardware Wizard screen will pop up when the adapter is installed

correctly. Click Cancel.

2.2 Software Installation

2.2.1 For Windows® XP

The Setup steps for Windows® 2000 and Windows® XP are similar with each other. This user

guide takes Windows® XP for example.

1. Insert the Resource CD into your CD-ROM drive. To continue, double-click My Computer,

and then double-click the CD/DVD drive where the installation CD was placed. Open

APPUSB300 folder, and double-click Setup.exe. Then you will see Figure 2-1.

Figure 2-1

2. Soon, Figure 2-2 will display after a moment. Click Next to continue.