User`s manual

7800 Series Hysteresisgraph System User's Manual
4-14 Operation
4.1.5.2 Run Sequence
The 7800 Software has the ability to automatically name a sequence of measurements. All samples measured
as a group must work with a single sensing coil configuration. This dialog box is also called by clicking the
Meas. Group button on the main screen.
Root Name: Enter the root name of the measurement. In the example shown above, the root name is
“Ferrite.” In this case, all subsequent file names would be prefaced with Ferrite. For
example, Ferrite0001, Ferrite0002, Ferrite0003, etc.
Start Number Enter the number to begin the sequence. Be sure to include sufficient places to cover the
total number of expected measurements.
Cancel Cancel measurement.
Run Sequence: Begin the auto-file naming sequence.
4.1.6 DATA ANALYSIS MENU (Supervisor Mode Only)
The Data Analysis Menu consists of the Current Measurement Summary in Paragraph 4.1.6.1, Data Processing
in Paragraph 4.1.6.2, and Permeance in Paragraph 4.1.6.3. These menu selections are only available when the
Hysteresisgraph software is operating in Supervisor Mode.
4.1.6.1 Current Measurement Summary
The Current Measurement Summary dialog box can be summoned by selecting under the Data Analysis menu
or clicking the Curve Info button. This entire display is for information only and represents a summary of
entries made in other parts of the program. No entries can be made in this dialog box.
4.1.6.2 Data Processing
B vs. H Curve Check to display the Normal Induction curve.
(B-H) or J vs. H Curve Check to display the Intrinsic Induction curve.
The following selections control the display of tabular data on the main screen of the system software. To turn
on/off the display of the item, check/uncheck the corresponding checkbox. The quality control field is used to
turn on or off the QC checking for the item of interest.