User`s manual

7800 Series Hysteresisgraph System User's Manual
Operation 4-13
4.1.5.1.1 Rectangular Cross Section
If your sample has a rectangular cross section, the dialog box allows you to enter the X and Y dimensions.
The resulting cross section is calculated. Units are specified in Paragraph 4.1.3.4.
X: Enter your measurement of the X axis.
Y: Enter your measurement of the Y axis.
Magnetic Length: Enter your length measurement of the magnetic portion of your sample.
Cross Section: The software will calculate the resulting cross section.
4.1.5.1.2 Circular Cross Section
If your sample has a circular cross section, the dialog box allows you to choose the Outside Diameter,
Inside Diameter (if applicable), and the Magnetic Length. The resulting cross section is calculated.
Units are specified in Paragraph 4.1.3.4.
Outside Dia: Enter you measurement of the outside diameter.
Inside Dia: If the sample has a hole in the center, enter you measurement of the inside diameter.
If the sample has no hole in the center, enter zero (0).
Magnetic Length: Enter your length measurement of the magnetic portion of your sample.
Cross Section: The software will calculate the resulting cross section.
4.1.5.1.3 Complex Shape/Manual Cross Section
If your sample has a non-standard cross section, or one not listed above, choose the Complex Shape/Manual
C-S Calculation. Enter your pre-calculated cross section and the length of the magnetic material. The
resulting cross section is calculated. Units are specified in Paragraph 4.1.3.4.
Cross Section: Enter you measurement of the cross section.
Magnetic Length: Enter your length measurement of the magnetic portion of your sample.
Cross Section: The software will calculate the resulting cross section.