User`s manual

7800 Series Hysteresisgraph System User's Manual
Operation 4-9
4.1.3.4 Unit Select
For maximum flexibility, the units used for data entry do not have to be the same as the units used in the
display of measurement data on the main screen.
Data Entry Units/Length This area selects the units of length to be used in data entry. Unit choices are
millimeters (mm), centimeters (cm), meters (m), and inches (in).
Calculated Units/Area, A·N, etc. This area selects the units of area, area·turns (A·N), etc., to be used when
the software calculates data. Unit choices are square centimeters (cm
2
)/
square centimeter turns (cm
2
·T) and square inches (in
2
).
Display – Primary Units This area selects the primary display units. On the main screen, primary units are
shown in the left column of data and along the left and bottom side of the
graphic display. To further control the display of data on the main screen, refer
to the Axes button (Paragraph 4.1.9).
Display – Secondary Units This area selects the secondary display units. On the main screen, secondary
units are shown in the right column of data and along the upper and right sides
of the graphic display. To further control the display of data on the main
screen, refer to the Axes button (Paragraph 4.1.9).
Display Numerical Results in Secondary Units Check this box if you wish to display the numerical results
in secondary units. If unchecked, the right column of data and tickmarks/units
along the upper and right sides of the graphic display are not shown.