User`s manual

7800 Series Hysteresisgraph System User's Manual
3-14 Installation
Instrument Setup (Continued)
b. Press the Display Format key and use s or t key to select Location 3 and press the Enter key.
Use the s or t key to select Input 1 and press the Enter key. Use the s or T keys to select Min. and
press the Enter key.
c. Press the Display Format key and use s or t key to select Location 4 and press the Enter key.
Use the s or t key to select Input 1 and press the Enter key. Use the s or t keys to select Max. and
press the Enter key.
d. Press the Display Format key and use s or t key to select Location 5 and press the Enter key.
Use the s or t key to select Input 5 and press the Enter key. Use the s or t keys to select C and press
the Enter key.
e. Press the Display Format key and use s or t key to select Location 7 and press the Enter key.
Use the s or t key to select Input 5 and press the Enter key. Use the s or T keys to select Min. and
press the Enter key.
f. Press the Display Format key and use s or t key to select Location 8 and press the Enter key.
Use the s or t key to select Input 5 and press the Enter key. Use the s or t keys to select Max. and
press the Enter key.
5. Computer.
Right-click the desktop, go to Properties, and then to Settings. Change the desktop area to 1024 by 768 pixels.
Change the color palette to True Color. Click OK to accept the changes.
3.6 LAKE SHORE SOFTWARE INSTALLATION
The Lake Shore Software for the 7800 Series Hysteresisgraph System is pre-installed and tested at the factory
before shipment. A copy of the software is provided for archival and restoration purposes.
CAUTION: Do not install any software on the computer provided with the 7800 Series. Installing other
software programs may cause conflicts with the operation of the 7800 Series and can have
unintended consequences. Lake Shore assumes no responsibility for damage to the 7800
Series as the result of unauthorized installation of software.
If reinstallation of the software is ever required, the user should first attempt to uninstall the existing software
using Windows Add/Remove Programs. If the program is not listed or if the uninstallation is unsuccessful, go to
C:\Program Files\Lake Shore Torque Tester and double-click Unwise.exe.
To install new software, go to the Start menu and select Run. Type x:/setup where x is the drive that contains
the CD. Click OK. The program will step you through the installation. We recommend you use the default
directory for the installation and backup folders. Be sure to restart the computer following the installation.
3.7 REPACKAGING FOR SHIPMENT
If it is necessary to return any part of the 7800 Series Hysteresisgraph System for re-calibration, repair, or
replacement, a Return Goods Authorization (RGA) number must be obtained from a factory representative before
returning the instrument to our service department. When returning an instrument for service, the following
information must be provided before Lake Shore can attempt any repair.
1. System model number, instrument model number, and serial number.
2. User name, Company, address, and phone number.
3. Malfunction symptoms.
4. Description of system.
5. Returned Goods Authorization (RGA) number.
If possible, the original packing material should be retained for reshipment. If not available, consult Lake Shore
for shipping and packing instructions.
Because of their fragility, Lake Shore sensors are shipped in special cardboard and foam boxes. These boxes
should be retained for storage of sensors while the Temperature Controller is not in use. The same box can be used
to return sensors to Lake Shore for repair.