User`s manual

7800 Series Hysteresisgraph System User's Manual
3-12 Installation
3.4 IEEE-488 ADDRESS SETTINGS
Use the following procedure to set or verify the 7800 Series Hysteresisgraph System IEEE-488 addresses.
1. Lake Shore Model 480 Fluxmeter (Measures B field, unit on left side of panel).
a. Press the Interface key.
b. Press the Enter key to skip Baud Rate screen.
c. The IEEE address is displayed. Press the s or t key to select a setting of 18.
d. Press the Enter key to save the new address.
e. The terminators screen is displayed. Press the s or t key to select Cr Lf. Press the Enter key.
2. Lake Shore Model 480 Fluxmeter (Measures H field, unit on right side of panel).
a. Press the Interface key.
b. Press the Enter key to skip Baud Rate screen.
c. The IEEE address is displayed. Press the s or t key to select a setting of 19.
d. Press the Enter key to save the new address.
e. The terminators screen is displayed. Press the s or t key to select Cr Lf. Press the Enter key.
3. Lake Shore Model 218 Temperature Monitor.
a. Press the Interface key.
b. Press the Enter key to skip Baud Rate screen.
c. The IEEE address is displayed. Press the s or t key to select a setting of 21.
d. Press the Enter key to save the new address.
e. The terminators screen is displayed. Press the s or t key to select Cr Lf. Press the Enter key.
4. Lake Shore Model 450 Gaussmeter.
a. Press the Interface key.
b. Press the Enter key to skip Baud Rate screen.
c. The IEEE address is displayed. Press the s or t key to select a setting of 12.
d. Press the Enter key to save the new address.
e. The terminators screen is displayed. Press the s or t key to select Cr Lf. Press the Enter key.
5. Lake Shore Model 340 Temperature Controller.
a. Press the Interface key.
b. Press the s or t key to select Cr Lf. Press the Next Setting key.
c. Press the s or t key to select EOI On. Press the Next Setting key.
d. Press the s or t key to select Address 22. Press the Next Setting key.
e. Press the Save Screen key to save the new settings.
6. Computer.
a. Select Start/Settings/Control Panels and double-click the GPIB icon.
b. On the GPIB Configuration screen, select the Configure button.
GPIB_2.bmp