Specifications

7700/7800 MultiFrame Manual
7700ACO2-HD Dual HD/SD-SDI Smart Automatic Changeover
Revision 1.0 Page - 15
5. CARD EDGE MENU SYSTEM
5.1. CARD-EDGE CONTROL
The 7700ACO2-HD is equipped with a push-button shaft encoder and a four character dot matrix display
to control various functions on the module. The push-button shaft encoder is used to navigate through a
menu system to set and monitor various parameters for the module.
5.2. NAVIGATING THE CARD-EDGE
The push-button shaft encoder is used to move up and down the list of available parameters to adjust. To
adjust any parameter, use the shaft encoder to move up or down to the desired parameter and then press
the shaft encoder in. If the parameter is a numerical value, the number will increase if you rotate the
shaft encoder clockwise and decrease if you rotate the shaft encoder counter-clockwise. If the parameter
contains a list of options, you can cycle through the list by rotating the shaft encoder in either direction.
The parameter values are changed as you cycle through the list. A menu choice or selection is chosen by
pressing the shaft-encoder in.
After selecting a parameter, the menu display will change back to the previous menu item. To change
another parameter, rotate the shaft encoder to select other parameters. If the shaft encoder is not
operated for several seconds the card edge control will exit the menu system and return to an idle state.

The preferred method of configuration is via SNMP (VistaLINK
®
). Many settings
(such as IntelliGain and IntelliTrak) are not available via card edge control.