Owner`s manual

26
XDMA7800
Bluetooth
®
Operation
MostBluetoothdevicessupporttheauto-connectfeature,andwillconnectautomatically
ifthedeviceisinrangewhentheXDMA7800ispowered-on.Ifyourdevicewaspreviously
pairedbutdoesnotconnect,usetheseinstructionsbelow.
•IfyourmostrecentlyconnectedBluetoothdevicebecomesdisconnectedordoesnot
reconnect,press fromBluetoothmodetoreconnectyourmobiledevice.
•Toconnectapreviouslypaireddevicethatwasnotrecentlyconnected:
1)Ifapplicable,pressandhold todisconnectanyconnectedmobiledevices.
2)FromBluetoothmode,pressSELECT."PairedDevices"willappearontheLCD.
3)Turnthevolumeknobtocyclethroughthelistofdevices1through10.
4)PressSELECT or toconnecttothedesireddevice.Itmustbeinrangetoconnect.
Note:IftheAuto ConnectsetupmenusettingissettoOFF,youmustpress to
connectyoudeviceafterpairing,andeachtimetheXDMA7800ispowered-on.
Pressandhold for3secondstodisconnectaconnecteddevice.Thedevicewillremain
pairedandappearinthePAIREDDEVICESmenu,butnotbeconnected.
BeforeyoucanuseaBluetoothdevice,itmustbepairedand
connected.MakesurethatBluetoothisactivatedonyour
devicebeforeyoubeginthepairingprocess.
TheXDMA7800broadcaststhepairingsignalconstantly
whennodevicesarecurrentlyconnected.Completethe
pairingsequencefromyourBluetoothdevice.Refertothe
owner'smanualforyourdeviceformoredetails.
The device name is "XDMA7800"
The Bluetooth passcode "1234"
Note:TheXDMA7800canbeinanymodeofoperation
whenpairingisperformed.
Ifadeviceiscurrentlyconnected,pressandhold to
disconnectthecurrentdevicebeforeanewdevicecan
bepaired.Thenbeginthepairingsequencefromthenew
Bluetoothdevice.
Preparation
Pairing a New Device
Pairing Additional
Devices
Pairing a Device
Connecting a Paired Device
Disconnecting a Device