Installation guide

2 7800 Series Keypad Installation Guide
Touchscreen Display
The 7800 Series keypads have an integrated LCD touchscreen user interface. The
display can be set up to display a custom logo image on the main screen. See the
Custom Dealer Logo section below. The display can also be programmed to turn
off (blank screen) during periods when the keypad is not in use. See Backlighting
Brightness under End-User Options.
Warning: DO NOT use any sharp objects to operate the touchscreen such as a pen or
pencil.
Cleaning the Touchscreen Display
Select the keypad option from the main carousel menu until it glows and clean the
touchscreen using a water dampened soft, lint-free cloth. Apply the water onto
the cloth, do NOT apply directly onto the touchscreen. After cleaning, wipe the
touchscreen dry with a soft, lint-free cloth. Touch the back arrow before returning to
the main screen.
Micro SD Card
The 7800 Series keypads provide a spring-loaded Micro SD card slot on the right edge
of the keypad housing. This is used to load a custom logo onto the main screen. Insert
the Micro SD card straight in, with the contacts facing the wall, pressing in until a
click occurs from the spring mechanism. To remove the Micro SD card, gently press in
to allow the spring to eject the card. Grasp the edges of the card with two ngers
and remove.
Custom Dealer Logo
To display a custom dealer logo on the main screen, contact DMP Marketing at
1-800-641-4282 or [e-mail] for information. To add a custom dealer
logo, see the Dealer Logo option under Installer Options menu.
Installing the Keypad
All DMP keypad housings are designed to easily install on any
single-gang switch box or at surface. Figure 6 shows the keypad
housing base mounting hole locations.
Remove the Cover
The keypad housing is made up of two parts: the cover, which
contains the circuit board and components, and the base. Use the
following steps and gures to separate the keypad cover and base:
1. Insert a at screwdriver into one of the slots on the bottom of
the keypad and gently lift the screwdriver handle toward you
while pulling the halves apart. Repeat with the other slot.
2. Using your hands, gently separate the front from the base and
set the cover and components aside.
Micro SD
Card Slot
ARMED
TODAY
WEDNESDAY
Panic
Chime
Check-in
Reset
MON 5:35 AM
82
CURRENT
HI LO
98 77
80
LO
74
HI
Figure 2: Micro SD Card Slot
Graphic
Keypad
Building Wall
Insert small
screwdriver and
lift to remove
cover.
Do not twist.
Figure 3:
Removing the
Keypad Cover