Installation guide

8 7800 Series Keypad Installation Guide
Installer Options Menu
Keypad Options and Keypad Diagnostic menus allow installing and service technicians to
congure and test keypad operation.
Access the Installer Options Menu
Access the Options menu through the carousel menu. While in the Option display, press the
Installer Options icon and enter the code 3577 (INST) at the keypad and press CMD.
The Options menu allows you to set the keypad address, select Supervised or Unsupervised
mode, selectively enable the Panic keys, Bypass, Request-to-Exit, and set entry
card options.
Note: All programming options display on all keypad models, however, actual operation for
some programming options is restricted to the appropriate model.
Programming Keypad Options
KPD KPD
OPT DIAG STOP
Keypad Options (KPD OPT)
To program keypad options, press KPD OPT.
CURRENT KEYPAD
ADDRESS: 01
Keypad Address
Set the keypad address from 01 to 08 with the XT30/XT50,
01 to 08 with the XR100 and XR150 Series, 01 to 16 with the
XR500 Series, and 01 to 16 with the XR350/XR550 Series.
The default address is set at 01. To change the current
address, press the address display and enter the new
address. It is not necessary to enter a leading zero for
addresses 01 to 09.
KEYPAD MODE:
SUP * UNSUP
Keypad Type
Congure the keypad for either Supervised or Unsupervised
operation. Keypads with zones connected to them must be
supervised and cannot share an address with other keypads.
Unsupervised keypads can operate together sharing the same
address. Zones cannot be used on unsupervised keypads.
To change the current setting, press the SUP or UNSUP. An
asterisk appears next to the selected option.
Note: Unsupervised addresses cannot be used when Device
Fail Output has a programmed value other than zero.
Default Keypad Message
Enter a custom message of up to 16 characters to appear on
the keypad display top line whenever that line is not used
for any other purpose. Press any Select area to clear the
current message and enter a new custom display.
ARM PANIC KEYS:
*PN *EM *FI
Arm Panic Keys
Use this option to congure the Panic Icons. To enable
or disable a Panic Icon, press the icon name: PN (Panic),
EM (Emergency), and FI (Fire). Once the panic icon is
enabled, an asterisk displays next to the description and the
respective Panic icons display for the user. Refer to the Panic
Icon Options section in this document.
DEFAULT KPD MSG: