Instructions

Prototype Engineering Series
APPLYLABWORK PRINTING INSTRUCTIONS
Post-curing (Mandatory):
Submerge the parts into glycerol/glycerin(CAS # 56-81-5) and start FormCure with 60 ℃ /
30 mins
setting. Wash off glycerol in water and dry off with paper towel.
* If prints don’t sink completely into glycerol, add water (no more than half of volume) to
adjust liquid density.
** If prints are still tacky to touch after post-curing, rinse with acetone (CAS # 67-64-1) for
no more than 1 minute will significantly reduce tackiness.
Storage:
• Keep resin away from heat and light.
• NOT accessible to children.
Note:
• Keep printing environment well ventilated.
• Wear gloves when handling Spring resin and avoid direct contact.
• Vibration of the parts during printing process might cause resin splash onto printer ’s
cover. Use paper towel and IPA to clean immediately.
• Don’t leave the parts on building platform after printing for more than one day.
• Spring resin should NOT use with food, drink, or on/in the human body unless
specifically indicated.