Instructions
Prototype Engineering Series
APPLYLABWORK PRINTING INSTRUCTIONS
MSLA Spring Black
(MPT-SP001BK)
Check:
• Resin tank and LCD screen are clean
• Shake resin bottle well before use
• Tank and plateform are properly fastened
Printer Settings Recommendation:
Brand
Model
Layer
height
(mm)
Bottom
Layer
counts
Exposure
time
(s)
Bottom
Exposure
(s)
Lifting
Speed
(mm/min)
Lifting
Distance
(mm)
Retract
Speed
(mm/min)
Phrozen
Sonic
0.1
6
4
30
60
8
120
Sonic
mini
0.1
6
5.5
30
60
8
120
Sonic
Mighty
4 K
0.1
10
4
60
60
8
120
Elegoo
Mars2
Pro
0.1
6
3.6
30
60
8
120
Mars3
0.1
6
3.6
30
60
8
120
Layer
height
(mm)
Bottom
Layer
counts
Exposure
time
(s)
Bottom
Exposure
(s)
Lifting
Speed
(mm/s)
Lifting
Distance
(mm)
Retract
Speed
(mm/s)
Anycubic
MonoX
0.1
6
2.2
30
1
8
2
- Light-off Delay = 15s under current lift-retract motion.
[ When printing large object, increase Lifting Distance and recalculate Light-off Delay ]
- For Sonic Mighty 4K, please set Transition Layer Count to 20
*Light intensity varies each printer. Please adjust exposure time ±0.1~0.5 second and/or XY
dimesion ratio according to printing result and part application.
Parts Recommendation:
• Avoid large aspect-ratio geometry (e.g. thin wall or long thin rod) in the sturcture to
reduce failures.
• If support is needed, please set contact diameter>1.2(mm), and density>60%
Washing:
Wipe off excess resin on printed parts with paper towel, submerge into 95% IPA and place
the container in ultrasonic bath, wash for 5 minutes. Replace by clean IPA and repeat
ultrasonic washing for another 5 mintes (total 10 minutes). Blow off all excess IPA and set
parts in a shaded, ventilated place to dry at least 2 hours before curing.
*Dried print will be tacky to touch