User's Manual

Page 9

that the system operates the same no matter which remote sends a command and all LED’s

accurately reflect the true status of the system. Mixing settings on remotes can cause

unpredictable behavior and is NOT RECCOMENDED.

Frequency Settings

Before setting up patches and programs, you must first select a frequency for your system. If

other bands member have FXConnectX systems, be sure to select different frequencies!

There are two sets of switches on each remote and one on the Main Unit. On the Floor unit

these are located on the rear panel. On the Body Pack these can be found inside the battery

compartment area under the rear cover. On the Main Unit it is on the bottom panel.

Set each to the exact same frequency before attempting to use your new system.

 Frequency Select Switch: This is a 4 position switch. There are 16 unique

frequencies that can be selected for use. Select one of the 16 frequencies and set

the Main Unit and each remote to the exact same setting. If more than one

FXConnectX system (main units) are used you must ensure that each system is

on a different frequency to eliminate the possibility of interference.

Remotes – Body Pack and Floor Unit