User's Manual

Page 8

 Below is a picture of the Mode properly set for this example. This sets all

channels to Patch mode except Mute; which is set to toggle on and off:

o Sample Patch Setup for Chain Sample 1:

 Patch 1 “Clean1”: L2 Chorus, L4 Delay, AB off (amp clean channel)

 Set patch to Button 1: 2 and 4

 Patch 2 “Clean2”: L2 Chorus, L3 Phaser, AB off (amp clean channel)

 Set patch to Button 2: 2 and 3

 Patch 3 “Dirty1”: L2 Chorus, L4 Delay, AB on (amp dirty channel)

 Set patch to Button 3: 2, 4, AB

 Patch 4 “Dirty2”: L3 Phaser, L4 Delay, AB on (amp dirty channel)

 Set patch to Button 4: 3,4,AB

 Patch 5 “Lead”: L1 EQ/Dist, L4 Delay, AB on (amp dirty channel)

 Set patch to Button TS1: 1,4,AB

 NOTE: (Unused TS1,2 or AB buttons can be used for patches when

set to “patch” position)

It is very important that the FREQUENCY (Labeled: UNIT/CHANNEL GROUP CONTROL)

and CHANNEL MODE SELECTION switches are set EXACTLY THE SAME on each Body Pack

and Floor Unit used with the system and that each remote is programmed identically. This is so