User's Manual

Page 11

 Channel (Loop) Mode Selection: Toggle, Patch, or Momentary (On the Body Pack

this is the 8-gang switch under the battery cover or on the rear panel of the floor

units)

o Toggle: Each press of the associated button will turn the channel on or off

just like stomping on an effect pedal. Channels set to Toggle cannot be part

of a patch.

o Patch: Allows the channel to be part of a patch program.

o Momentary: Allows the associated channel to be ON when the button is

held down, upon release the channel is turned off. This is especially useful

for TAP/Tempo controllers. Channels set to Momentary cannot be part of

a patch.

It is very important that all switches are set EXACTLY THE SAME on each Body Pack and

Floor Unit used with the system and that each remote is programmed identically. This is so

that the system operates the same no matter which remote sends a command. Mixing settings

on remotes can cause unpredictable behavior and is NOT RECCOMENDED.

Remote Patch Edit

NOTE: Please visit our web site to view sample programming videos. www.fxconnectx.com

Let’s use the following Sample patch to program a Floor Unit Remote:

Patch 1 Name: “Clean-1”which will include L2 Chorus, L4 Delay, and AB off (amp clean

channel)

Assign Patch 1 to Button 1. This will be “Clean-1.” This patch will include channels 2

and 4 (L2 Chorus, L4 Delay). AB is default off but shown here because we are using

the clean channel for reference. For dirty, it would be included and turned ON (or vice-

versa depending on your amp).

Steps:

1. Turn off the Main Unit and Ensure that the Remote Unit power is off.