User's Manual
Table Of Contents
- UA-612 Installation Sheet V1.2
- Reader Description
- Parts List
- Installation Procedure
- Product Specifications
- Cable to Controller and Power Supply
- Reading Distance
- Notes
- 1. Connect the black wire (negative) first, and the red wire (positive) last. Disconnect power before any wiring changes.
- 2. The LED and Beeper lines are logic levels. Never apply power to them. They may be pulled to a low level (0 to 1.2 VDC) to enable their functions, and left floating or pulled to a high level (3.6 to 5.0 VDC) when not used.
- 3. UA-612 readers have both Wiegand-protocol and RS-232 serial interfaces. For information on RS-232, contact AWID’s technical support.
- 4. For additional information, please visit AWID’s Web site www.awid.com. For technical support questions visit www.awid.com/support or call 1-800-369-5533 (in the U.S.) or 1-408-825-1100 from 8:00 a.m. to 5:00 p.m. Pacific Time.
- 5. FCC Compliance: This equipment has been tested and found to be in compliance with the limits for FCC part 15, Class A digital device. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instruction manual, may cause harmful interference with radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
- The users are prohibited from making any change or modification to this product. Any modification to this product shall void the user’s authority to operate under FCC Part 15 Subpart A Section 15.21 regulations.
- This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- UserManual
MPR-2010-2.7E4-CN Page 5 7/22/2008
1 INTRODUCTION
AWID’s MPR-2010-2.7E4-CN long-range (12 to 15 feet) Radio Frequency IDentification
(RFID) reader family/series consists of Sentinel-Sense versions with RS-232 interface
(BR) and TCP/IP interface (BN) and Sentinel-Prox version (LR-911) with Wiegand
interface that work with most leading UHF passive tags. The reader comes with a
unique combination of long read range, small size, and low power consumption. It has
an internal power converter, allowing it to work with a wide range of supply inputs
without affecting its performance. Its primary applications are asset management and
tracking, and fleet management applications.
1.1 SPECIAL FEATURES
1.1.1 Sentinel-Sense Model (BR or BN)
• Multi-Protocol: ISO-18000-6 Type B , EPC Class1
1
Gen 1 & 2
• Thin passive tags with long-range performance
• High performance circular polarized antenna
• RS-232 data input/output by BR
• TCP/IP interface by BN
• Splash proof design for indoor or outdoor applications
• UV stabilized housing
1.1.2 Sentinel-Prox Model (LR-911)
• Thin passive tags with long-range performance
• Designed for automated operation with tags mounted on automobile’s windshield
• Simultaneous Wiegand (Access Control) and RS-232 (transaction control)
outputs
• Permanently sealed electronics for indoor or outdoor applications
• UV stabilized housing
•
1
Both 64- and 96-bit