User's Manual
Table Of Contents
- UA-612 Installation Sheet V1.2
- Reader Description
- Parts List
- Installation Procedure
- Product Specifications
- Cable to Controller and Power Supply
- Reading Distance
- Notes
- 1. Connect the black wire (negative) first, and the red wire (positive) last. Disconnect power before any wiring changes.
- 2. The LED and Beeper lines are logic levels. Never apply power to them. They may be pulled to a low level (0 to 1.2 VDC) to enable their functions, and left floating or pulled to a high level (3.6 to 5.0 VDC) when not used.
- 3. UA-612 readers have both Wiegand-protocol and RS-232 serial interfaces. For information on RS-232, contact AWID’s technical support.
- 4. For additional information, please visit AWID’s Web site www.awid.com. For technical support questions visit www.awid.com/support or call 1-800-369-5533 (in the U.S.) or 1-408-825-1100 from 8:00 a.m. to 5:00 p.m. Pacific Time.
- 5. FCC Compliance: This equipment has been tested and found to be in compliance with the limits for FCC part 15, Class A digital device. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with instruction manual, may cause harmful interference with radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
- The users are prohibited from making any change or modification to this product. Any modification to this product shall void the user’s authority to operate under FCC Part 15 Subpart A Section 15.21 regulations.
- This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- UserManual
MPR-2010-2.7E4-CN Page 2 7/22/2008
COPYRIGHT ACKNOWLEDGEMENTS
The contents of this document are the property of Applied Wireless Identifications Group, Inc.
(AWID) and are copyrighted. All rights reserved. Any reproduction, in whole or in part, is
strictly prohibited. For additional copies of this document please contact:
AWID
18300 Sutter Blvd
Morgan Hill, CA 95037
http://www.AWID.com
The information contained herein has been carefully checked and is believed to be accurate,
no responsibility is assumed for inaccuracies. AWID reserves the right to make changes
without prior notice. This document is not covered by any warranty either expressed or
implied. Any comments, corrections or additions to the contents of this document should be
directed to AWID at the above address.
Copyright 2006 AWID, Printed in USA.
All other trademarks are the property of their respective owners.